Cooling towers

  • Production of the whole range of components for cooling towers 
  • Design and “greenfield” construction for any needs 
  • Reconstruction of the existing cooling towers
  • Consultation on the selection of equipment for problems solving 

FRP (fiberglass) cooling towers 

  • Are designed taking into account current requirements.
  • Made of fiberglass, so that resistant to aggressive environment and does not corrode. This allows to use supplied by us cooling towers even in the toughest conditions.
  • Guaranteed to provide the specified temperature. 
  • Stable and reliable operation in hot weather.
  • Fast installation, ease of maintenance and repair 

Cooling tower fan 

  • Located outside the diffuser. 
  • Easy access to the drive block. 
  • Ability to work with the inverter. 
  • Productiveness is 1.5 times higher than that of traditional fans. 
  • High energy efficiency. 
  • Quick payback.  

Cooling tower filler 

  • Filler made of PP or self-extinguishing PVC. 
  • The possibility of using water with a very high degree of pollution without the risk of clogging.

Water distributing system 

  • Dish shaped atomizers allow to use the water with high content of salts and impurities without the risk of clogging. 
  • Normally made of PP, optionally can be made of stainless steel.

Automatic control system

  • Provides a smooth start. 
  • Provides “drying” of the electric motor. 
  • Provides “anti-freeze” mode.
  • Total control over the work of fan electric motors.

FRP advantages in comparison with galvanized steel structures. 

  • Durability is 4 times higher in comparison with galvanized steel under the most extreme operational conditions. 
  • Resistance to the effect of atmospheric conditions and ultraviolet radiation. 
  • Lack of corrosion and time-dependent damage due to its increased strength and resistance to aggressive chemical and biological effects. 
  • The cost of this material is 30% lower than the cost of galvanized steel;
  • There is no need for painting and repair, as a result – reduction of operating costs;
  • The strength is similar to steel, but the weight is 5 times less; resistance to abrasive wear;
  • Low thermal conductivity, as a result, the absence of frosting of the fan and the internal structure of the cooling tower;
  • Material is non-combustive and resistant to both low and high temperatures;
  • It is possible to assemble the cooling tower frame on the ground and install it further on the poolbasinwith the lift crane.